 |
Almost everyone has a dilemma when trying to come up with a gift to make for the guys. Here's a project that is quick and fun! Make it in a novelty print or embroider on the bottom pocket to match your gift giving needs. |
Materials Needed:
- Cotton fabric or a non scratching fabric (Novelty Prints are great for gift giving)
- Craft weight fusible interfacing
- Thread
- 1" wide Elastic ( 2 - 7" Pieces)
Cutting Instructions:
Cut 2 pieces of fabric 12" by 7" (Back both pieces with fusible craft weight interfacing)
| Cut 10 pieces (all with the right side of the fabric facing up) to the measurements shown in this diagram. |  |
Directions:
Note: All Directions use 1/2" Seam allowance!
On the angled edge of the pocket pieces, press under 1/4" and press under again, to enclose the raw edge. Stitch the hem.
 |
Starting 1/2 from one end, place the pockets an even distance from each other with the last pocket lining up with the end of the 12" by 7" piece. Placement should be approximately 5/8" apart. Pin the pockets in to place. |
Starting with the end pocket, stitch the pocket to the backing piece along the straight edge of the pocket. Once the pocket is stitched, fold it back out of the way and stitch the straight edge of the next pocket. Repeat until all the pockets are attached.
Lay all pockets flat and press. Baste the edges to hold the pockets in place.
Lay the elastic on top of the pockets 2" from each end. Stitch the elastic in to place in the 1/2" seam a allowance.
Take the second 12" by 7" piece and place it right sides together, on top of the pocket section. Starting on a 12" edge, stitch around the edges, leaving a 2" to 3" opening to turn the CD holder right sides out.
Trim the seam allowances (except at the area you left open) and the corners to eliminate bulk. Turn right sides out. Turn elastic to the back side.
Press the opening seam allowance inward, and press the whole CD holder flat.
Top stitch 1/4" from the edge all the way around.
 |
You will want the wide part of the pocket to be at the bottom. Adjust the direction you place the pockets to have a holder for the drivers side and the passenger side of your vehicle. |
